Operator Console (Qj-B Type); Operator Console (Oc) - GE CT ProSpeed Series Installation Manual

GE MEDICAL SYSTEMS
REV 15
3–2 OPERATOR CONSOLE (Qj–b TYPE)
This section applies to Qj–b Type OC.
For Zj Type or Zj–a Type OC, See Section 3–3, OPERATOR CONSOLE (Zj/Zj–a TYPE).
3–2–1

Operator Console (OC)

The OC contains a hard disk drive unit and other fragile equipment.
Take care when moving the OC unit.
1. Move the OC to the Operator Console room using its casters.
Position the OC so the operator can see the patient on the table from the console.
2. Remove the LCD touch panel tilt angle adjustment plate under the LCD touch panel and pivot the touch screen
into place; ask the customer what angle is best or adjust the screen to minimize glare.
Refer to Section 1–6, TOUCH PANEL (LIQUID CRYSTAL DISPLAY), of tab 1 of the Component Replacement
manual (2124012), if necessary.
3. Remove the two rubber caps and two screws from the top of the Operator Console and remove the top cover to
allow access for system wiring
Refer to Section 4, SYSTEM POWER, GROUND AND CABLE INTER–CONNECTION.
4. Remove the rear (upper and lower) and front covers to allow access for system wiring.
FRONT VIEW
Note
NOTICE
Note
LCD TOUCH
PANEL
TILT ANGLE
ADJUST-
MENT
PLATE
TOP VIEW
OPERATOR CONSOLE
ILLUSTRATION 3–12
3-17
CT PROSPEED SERIES INSTALLATION
OC REAR VIEW
2124011