Safety Notes; Laws And Directives - Siemens SITRANS F M MAG 5000 Manual

2

Safety notes

2.1
General requirements
Instrument safety standards
Environmental conditions according to IEC 61010-1 (2001)
www.eltra-trade.com
CAUTION
Correct, reliable operation of the product requires proper transport, storage, positioning and
assembly as well as careful operation and maintenance. Only qualified personnel should
install or operate this instrument.
Note
Alterations to the product, including opening or improper repairs of the product, are not
permitted.
If this requirement is not observed, the CE mark and the manufacturer's warranty will expire.

Laws and directives

Installation of the equipment must comply with national regulations. For example EN 60079-
14 for the European Community.
The device has been tested at the factory, based on the safety requirements. In order to
maintain this condition over the expected life of the device the requirements described in
these Operating Instructions must be observed.
● Indoor use
● Altitude up to 2000m
● Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreasing linearly
up to 50% relative humidity from 40°C (104°F)
● Main supply voltage fluctuations up to ±10% of the nominal voltage (see technical
specifications)
● Overvoltage category II
● Pollution degree 2
info@eltra-trade.com
2
11
+421 552 601 099