Changing Operator Menu Setup - Siemens SITRANS F M MAG 5000 Manual

Changing decimal point position
Changing units
6.6
Customizing menus in operator menu
Changing text in line 1
Enabling two readings
www.eltra-trade.com
1. Enter the respective totalizer menu.
2. Use select key to position cursor below decimal point.
3. Use change key
1. Use select key to position cursor below unit.
2. Press change key

Changing operator menu setup

In the operator menu the menus required for daily operation of the flowmeter are shown. It is
possible to hide and change some of the menus in the operator menu. This is done in the
operator menu setup menu, see operator menu setup diagram.
To customize the menus in the operator menu perform the following steps:
1. Press top up key
2. Enter password.
3. Use forward key
1. Press lock/unlock key
2. Use change key
3. Press lock/unlock key
Note
If "Text" is selected in line 2, this line functions as a heading for the value shown in line 3.
Otherwise it shows the actual value of the reading selected.
1. Use forward key
2. Press lock/unlock key
3. Use select key to move cursor to upper line.
4. Use change key
5. Press lock/unlock key
to move decimal point to requested position.
until requested unit is displayed.
for 2 sec.
or backward key to reach operator menu.
to unlock setting.
to select desired text.
to confirm selected text.
to reach requested menu.
to unlock setting.
to select requested reading.
to confirm selection.
info@eltra-trade.com
Commissioning
6.6 Changing operator menu setup
+421 552 601 099
45