Starting Engine - Regal LS4 Owner's Manual

Starting Engine

Before Starting Engine
Note that it is important that you read and
understand the engine operator's manual carefully
and become completely familiar with the operation
as well as required maintenance procedures on the
engine and related propulsion systems.
Before starting the engine check the guidelines
below:
1. Open the engine hatch and sniff for fuel smells
and visually check for fuel leaks. If gasoline vapors
are sensed or leaks seen be sure to determine the
cause and repair the source before starting the
engine. If you can not locate a fuel leak contact
a marine professional immediately or your closest
Regal dealer.
1 A. Always run the bilge blower at least 4 minutes
before attempting to start the engine. Continue to
run the blower after the engine starts below cruis-
ing speeds.
2. Remove any loose canvas and store in a dry
location.
3. Shut and secure all portholes and doors.
4. Make sure the swim ladder is secured in its folded
position and that the cover if installed is in place.
5. Check fuel supply levels. Use the fuel "1/3" rule.
6. Turn battery switch to the "on" position at the
battery panel.
7. Activate the VHF if installed and listen for the
latest weather conditions along with performing a
radio check.
8. Activate the plotter and check its function, set up
your cruise, and monitor engine read-outs once the
engine has started.
natural and powered ducts provide a continual air
supply to the engine compartment and evacuate any
fumes along with warm air. Sometimes insects make
nests in the vent ducts. Lift the aft cushion on both
port and starboard sides to access the ventilation
ducts/grilles.
Starting Engine
After the preliminary checks are performed the
engine is ready to start. Insert the ignition key into
the ignition panel key switch hole. Note that the key
switch shows three positions;
A B C
A) S
traight Up= "Off"
B) 45 Degree Angle to Right= "Ignition" or "On"
C) Spring Loaded Furthest Right= "Start"
Check to ensure that
all ventilation duct
grills are clear of
foreign objects. The
85