Water Sport Tow Pylon; Ski Pylon Over Ride Switch - Regal LS4 Owner's Manual

Water Sport Tow Pylon

TYPICAL WATER SPORT TOW PYLON
As an option a water sports pylon may be installed
on your vessel. Read and understand the warning
label and installation instructions prior to using the
pylon.
Note the correct line end loop confi guration above
for water sports activity. Always use a 3rd person
spotter to keep a constant lookout for the person
engaged in water sports. Do not pull more than 1
person at a time from the pylon. Use pylon only for
kneeboarding, water skiing, wakeboarding or wake
surfi ng.
Do not exceed the pylon maximum pull load of 400
pounds as stated in the above warning label.

Ski Pylon Over Ride Switch

tilt switch stops to prevent the outboard shroud
(cover) from contacting and possibly damaging the
ski pylon. To continue trimming/tilting press both the
over ride switch and the outboard trim/tilt switch.
Note that if the ski pylon is not installed the above
steps still must be followed to trim/tilt the drive
beyond the stop angle.
The ski py-
lon over ride
switch is nor-
mally located
at the helm
area forward
of the remote
control on the
gunnel bolster
p a d . Wh e n
the outboard
is trimmed/
tilted to a set
angle the trim/
200