Diagnostic - ABB JDF300 Operating Instruction

26 J D F 3 0 0 | F I E L D I N D I C ATO R | O I/ J D F 3 0 0 - E N R E V. B

Diagnostic:

Resource Block FD_Diagnostic bits. (Indexes 47, 48, 49, 50):
Bit Root error Description
HMITB NormalMode = AUTO
Function
0 and
Check
HMITB TargetMode NOT = AUTO
MAO in
3 MAO.ActualMode = OOS
OOS
MAO.TargetMode = AUTO
MAO not
4 and
Scheduled
MAO.ActualMode = OOS
Not even one MAO input
enabled.
MAO inputs
5
all disabled
Electronic
30 Memory Memory data corrupted
Fail
Electronic
NV Configuration data are not
31
memory well stored in NV memory
burn fail
6 - 31 Undefined -.-
The SW4 of the electronics is
-.-
in ON position
The Selected input
(MAO_Channel) has been
disable into IN_ENABLED.
From this picture the
MAO_Channel is set to 1
(IN1) but
-.-
HMITB_IN_ENABLED bit 0
has been cleared.
Possible cause NE 107
HMITB TargetMode = OOS
or C
HMITB TargetMode = MAN
MAO.TargetMode = OOS C
FBAP not downloaded M
HMITB.IN_ENABLED = 0 M
Memory failed F
NV memory defect M
-.- -.-
The operator has
erroneously disabled the
input
Block Error
HMI code Suggested action
bit setting
- Set HMITB NormalMode = AUTO.
HMITB- OOS
C002.000 and/or
None set
- HMITB TargetMode = AUTO
Check the MAO TargetMode and, if
MAO-OOS C090.003
not in AUTO, switch to AUTO
MAO-Other Download a FBAP where the
M110.004
MAO-OOS MAO is instantiated
RB-Configuration Enable at least one input in the
M080.005
error HMITB.IN_ENABLED
RB-Lost NV Electronic should be replaced as
F150.030
data soon as possible
Electronis should be replaced
RB-Device
when possible if do not want to
needs maint. M130.031
re-configure the device at every
soon
power cycle
-.- -.- -.-
Proceed with the simulation of
RB-Simulation
an error bit or return the SW4 to
Active
OFF
Enable the selected input into
HMITB_IN_ENABLED if it must to
be used otherwise select another
input with MAO_Channel of those
enabled into HMITB_IN_ENABLED