Warming Bed - Dräger Babytherm 8004 Instructions For Use Manual

Preparation
2
2 Lower X-ray tank into the bed – the pegs
engage in the holes in the X-ray tank.
 Prepare the warming bed, see page 30.

Warming bed

The bed is enclosed by two side panels and two
end panels that can be opened independently of
one another.
The side panels are provided with holes for
secretion and drainage hoses.
The end panels have flexible grommets for hoses
and cables.
Fitting the panels
2
1
1 Insert the lower mounting pins of the panel
hinge-pieces into the guide slots on either side.
With the panels on the long side, ensure that
the handle points outwards.
 Position the panel semi-upright,
2 press the panel down firmly until the pins lock
into position at the bottom of the slots.
30
 Fold the panel up into the vertical position and
allow it to drop into the locking position.
 Fit all four panels in this way.
Make sure the panels fit correctly!
To open:
2
 Lift the panel all the way up until the upper pins
come out of their slots, then fold the panel
down.
With lively infants or older children:
 Use 230 mm high panels.
Fitting the inner panels
WARNING
Inner panels should be used with all patients,
regardless of whether the side panels are up
or down!
Otherwise the patient may fall out!
2
 Insert the pins into the tapered holes in the
corners of the housing and press down lightly
until the inner panel is firmly in place.
Make sure the panels fit correctly!
1
Instructions for use Babytherm 8004/8010