Weighing With Zero Calibration - Dräger Babytherm 8004 Instructions For Use Manual

Configuration mode

Weighing with zero calibration

Preparing for weighing
 Remove all objects that are simultaneously in
contact with both the bed and the fixed
environment or frame of Babytherm.
 Prepare the patient for lifting.
Switch on the display unit of the scale
 Plug the power plug into a power supply socket.
1 Press the Start/Standby button.
The display unit runs through a self-test and briefly
displays the message Scale.
– 1 beep is emitted. Weighing begins.
Starting the weighing process
2 Press the Weigh button.
– 1 beep is emitted. Weighing begins.
When the Lift Patient
 Lift the patient off the bed. Take care not to
touch the bed and frame of the Babytherm.
– 2 beeps are emitted. 0.00 is displayed on the
screen.
When the Lower Patient
 Lay the patient on the bed.
The weighing operation is performed.
80
kg Lb
1
kg Lb
2
indicator lights up:
indicator lights up:
– A line of dots is displayed on the screen.
– 3 beeps are emitted.
Weighing is complete.
– The weighing result is displayed on the screen.
The weighing result remains on the display for a
few minutes. If you need to check the weight, a
weighing procedure without zero calibration can be
performed within the next 3 minutes.
Weighing without zero calibration
If the last zero calibration was performed no longer
than 3 minutes earlier and no object has been
removed from the bed or placed on it during this
time, repeated calibration is not necessary.
1 Press the Reweigh button.
– The patient must be lying on the bed.
The weighing operation is performed.
– A line of dots is displayed on the screen.
– 3 beeps are emitted.
Weighing is complete.
– The weighing result is displayed on the screen.
After a few minutes, the scale display unit changes
to Standby mode.
– A continuous sequence of dashes is displayed
on the screen.
Instructions for use Babytherm 8004/8010
kg Lb
1