Switching On; Manual Operation - Dräger Babytherm 8004 Instructions For Use Manual

Switching on

After switching on, the system runs a self-test and
then proposes the following default operating mode
for the radiant warmer:
1
– No skin temperature sensor connected = man.
(manual)
– Yellow skin temperature sensor for near-core
temperature connected = Skin (skin
temperature control mode).
1 The yellow LED for the mode selected will flash
in the button.

Manual operation

The heater is controlled manually in the case of
short-term treatment or for infants in shock and for
whom baby control mode must not be used.
The radiant warmer delivers a preset power
regardless of the infant's body temperature!
CAUTION
When in clinical use do not leave this device
unattended! Measure the patient's core
temperature regularly using a separate
thermometer!
Check, whether both infrared radiators are
providing warmth by placing your hand carefully at
a safe distance from the radiant warmer.
Instructions for use Babytherm 8004/8010
If the system is still in Skin mode:
Babytherm 8010
2 Press button until the yellow man. LED in the
button starts to flash.
3 The following message appears on the display:
Set radiant heater level
Press OK button to confirm
4 Babytherm will propose the most recently calcu-
lated heater output setting as the default. (After
switching on, the default heater level is always 3.)
Each LED segment represents one heater
output level:
1 to 3 = green LEDs, radiant warmer power
10 mW/cm
4 to 10 = yellow LEDs, radiant warmer power
>10 mW/cm
5 Press OK button = confirm selected heating
level.
Or
6 Press
heater output setting is displayed.
5 Press OK button = confirm selected heating
level. If the OK button is not pressed within 10
seconds, the message disappears and the
previous setting will remain in effect.
4 Display of new selected heater output level.
2 Yellow LED in the button is lit continuously:
man. mode is now active.
3
4
2
6
2
2
.
or button until the desired
Operation
Babytherm 8010
5
47