Table of Contents
Advertisement
5
Testing the programmer for the first time
5a
Apply power to the programmer
5b
No Programming Projects Loaded
NO / INVALID
PROJECT LOADED!
5c
Check the programmer firmware version
EQUINOX-TECH UK
PPM3 Ver:-2.37
5d
Check the programmer serial number,
build revision and build date
SN:619 1.05
DATE 9-2-2003
6
Hardware installation is now complete.
PPM3 MKII Programmer - User Guide - V1.04 - 10
Programmer circuitry powers up to 5.0V.
FAIL LED flashes to indicate that the
programmer has rebooted.
The programmer display now initialises to
show the programmer type, firmware version
etc. See 5(b), 5(c), 5(d).
•
If the programmer has never been used
before or the on-board FLASH Memory
Store has been erased, then the
programmer will display the message:
'No / Invalid Project Loaded'.
•
It is not possible to check the
programmer information until a valid
project is uploaded. Please upload a
valid project to the programmer using
EQTools and then try again.
•
The programmer display now shows the
programmer type and the firmware
version.
e.g. 2.37.
•
You can check that you have the very
latest firmware version by viewing the
'Configit – Firmware Update Utility' on
the Equinox website.
After 2 seconds the display will update to show
the following information:
•
Serial Number (SN): eg. 619
•
Hardware Build Version: eg. 1.05
•
Build date: eg. 9 /2/2003
th
May 2008
21
Advertisement
Table of Contents
