Table of Contents
Advertisement
To execute a Programming Project in Standalone Mode:
#
Action
1
Connect the programmer to a spare PC COM
port
2
Apply power to the Programmer / Target
System
3
Upload your 'Programming Project(s)' to the
programmer
4
Disconnect power from the Programmer /
Target System
5
Disconnect the serial lead from the
programmer
6
Follow the instructions to program the Target
Device in Standalone Mode
34
Observation / comment
Programmer Target Vcc LED illuminates
See EQTools Manual – Project Upload Wizard
for full instructions.
Programmer is no longer controlled from PC
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
Advertisement
Table of Contents
