Instructions - Equinox Systems PPM3 MK2 User Manual

4.7.2 Instructions

The instructions below detail how to set up the programmer to supply a controlled voltage to the
Target System.
1. Create a Programming Project which powers the Target System
•
In EQTools – Project Builder – Select the <Target Power Supply Settings> tab
•
Set the required 'Target Voltage' and 'Tolerance' eg. 3.3V +/- 500mV.
•
The Voltage 'Stabilise Time' should be set to a long enough time to allow the voltage to reach
its final voltage (default: 200ms).
•
Under the 'Programmer Controlled Power Supply' section,
select: <Programmer controlled Target Power Supply: ON>
This enables the programmer to supply power to the Target System.
•
Enter the maximum current which your Target System could take from the programmer supply
(worst case i.e. current inrush condition)
•
Leave all other settings as the default values
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008 65