Equinox Systems PPM3 MK2 User Manual page 10

PPM3 MKII Programmer - User Guide - V1.04 - 10
Configit – Firmware Upgrade Utility
This utility is used to upgrade the firmware of the programmer if the
firmware version is < 3.00. A firmware update may be required to add
support for new devices and to correct any firmware issues.
Labview – Remote Application Control – Application Note
This upgrade allows a production facility to control a single
programmer from a 'Labview for Windows' application. The
Application note describes how to control the programmer using a
custom Labview (from National Instruments) application.
The following sources of documentation are available for this
software:
•
Application Note - Remote Application Control of ISP-PRO
Remote Application Control – Application Note
Describes how to control the programmer using a custom Remote
Application written in e.g. Visual Basic, C++, C Builder, Delphi etc.
ConsoleEDS Pro – Application note
This software utility allows any Equinox programmer to be controlled
via simple Command Line instructions from a Command Window
within Windows.
The following sources of documentation are available for this
software:
•
Application Note 111 – ConsoleEDS Manual
JTAG In-System (ISP) Upgrade – Application Note
This license upgrade enables the PPM3 Programmer to support
high-speed In-System Programming (ISP) of the Atmel ATmega
microcontroller family using the JTAG algorithm. Support is offered
for both single and multiple JTAG devices in a JTAG Chain.
Please refer to the following application note for further information:
•
Application Note 101
Error Message Descriptions
This document lists all the possible error messages which can be
generated by the EQTools / ISP-PRO applications.
th
May 2008 ix