Table of Contents
Advertisement
Features:
•
Plug-in 'I/O Connector Modules' – simply plugs into the mating sockets on the PPM3 Module
•
Different connector methods for interfacing to the Target System can be implemented by
simply plugging in the relevant 'I/O Connector Module'.
•
Programmer or Test Fixture can be easily swapped out without the requirement for unwiring
the Test Fixture
•
One programmer can easily be used with multiple Test Fixtures
•
New connection systems can be implemented using a new 'I/O Connector Module' without
requiring any redesign of the PPM3 Module.
•
IO-CON-2 Module supports 'wire-wrap' connections
•
IO-CON-1 / -2 support clip-in wire 'Fast Connect' wiring system
•
Target Vcc LED - illuminates when the 'Target Vcc' is detected
•
Auxiliary Power available via screw-terminal connections
1.3.2 Connector Systems currently supported
The following ISP connector systems are currently supported
•
Atmel 10-way ISP Header (SPI)
•
Atmel 6-way ISP Header (SPI)
•
Atmel 10-way ISP Header (JTAG)
•
Equinox 10-way ISP Header for Atmel T89C51Rx2 microcontrollers
•
Equinox 10-way ISP Header for Philips P89C51Rx2 and P89C66x microcontrollers
•
Wire-wrap (all devices)
•
Fast-Connect - plug-in wired connectors (all devices)
1.3.3 Programmers supported
The I/O Connector Modules are compatible with the following Equinox programmers:
•
PPM3 MK1 – Production ISP Module Version 1
•
PPM3 MK2 – Production ISP Module Version 2
4
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
Advertisement
Table of Contents
