Equinox Systems PPM3 MK2 User Manual page 48

4. Wait for the programmer to CRC check the Programming Project
•
The programmer performs a full CRC validation check of the entire Programming Project
stored in the programmer 'FLASH Memory Store'.
•
If the check is OK, the programmer goes to step (5).
•
If the check FAILS, the programmer will display 'Internal Image is corrupted'. Please try re-
uploading your Project Collection and then repeat the Standalone Mode process from the
beginning.
LCD Display
CHECKING IMAGE
PAGE n
Please note:
•
It is possible to switch off the 'Project CRC Image Check' function by disabling the 'CRC
check' in the Programming Project.
•
This feature is available in EQTools build 888 or above and firmware 3.07 or above.
5. Press the RED <YES> button again to execute the Programming Project
•
The Programming Project will now start to execute.
•
The <BUSY> LED will illuminate to denote that the programmer is active.
•
This may take a few seconds or a few minutes depending on the nature of the Programming
Project.
•
The Programming Project will either PASS or FAIL
LCD Display
Current programming
operation is displayed
6. Programming Project – PASS
If the Programming Project programs the target device without any errors:
•
The <PASS> LED will FLASH
•
The LCD will display: 'Operation Complete OK!'
•
Press <YES> key to program another device
LCD Display
OPERATION
COMPLETE OK
PPM3 MKII Programmer - User Guide - V1.04 - 10
Buttons Status LED
Display
Buttons Status LED
Display
To abort the
programming
sequence at any
time, press
Buttons Status LED
Display
Press
th
May 2008 37