Auxiliary Connector/Breakout Cable - FLIR X-Series User Manual

6.2.10

Auxiliary Connector/Breakout Cable

This connector provides access to a number of less commonly used input and output signals. The
inputs and outputs are easily accessed using the Aux Breakout Cable (P/N 4212860) supplied with
the camera. The camera auxiliary connector is a standard DB-26 (mating connector: Digikey PN
A31505-ND).
Pin Signal
2 TX
4 RX
5 GND
10 INTEG ACTIVE TTL
11 GND
14 Reserved
15 DIG_IN0
16 Reserved
17 DIG_IN1
18 Reserved
19 DIG_IN2
20 Reserved
21 TRIG_IN
22 GND
23 ANALOG_IN0
24 ANALOG_IN1
25 LOCKIN
26 GND
Here is an image of the breakout cable, and a closeup of the molded-in number on Cable 20, which is
reserved for future capabilities:
X-series User's Manual
Level Cable Molded-In Label
RS-232
Serial
RS-232
10
14
3V/5V CMOS 15
16
3V/5V CMOS 17
18
3V/5V CMOS 19
20
3V/5V CMOS 21
0-5V 23
0-5V 24
0-5V 25
6 – Interfaces
Connector Type
DB9 Female connector
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
BNC Male
76