Sync Tab - FLIR X-Series User Manual

Zoom
Centered
Same as FPA
Offset

5.4.2.3 Sync Tab

The Sync Tab allows the user to set the FPA sync mode, and sync/trigger options. At this point it is
helpful to define some terms. A sync is a signal that synchronizes the timing of an individual frame.
A trigger is a signal that synchronizes the start of a sequence of frames. The X-series has
independent SYNC and TRIGGER inputs. The SYNC and TRIGGER IN input require a 3.3V TTL
pulse (5V max).
X-series User's Manual
Zoom Modes
Because video modes have a fixed frame size, adjusting the
FPA window size can cause large empty areas around the
image in the video. The video zoom feature can reduce this
effect by applying a digital zoom factor to the image. The
available zooms are: x½, x1, x2, x4/3, x4. (4/3 zoom is good
for displaying a 640x512 image on a 720p display.
Analog Video Position Modes
FPA data is placed in center of analog frame
Uses Offsets from FPA sub-tab
Uses X & Y offsets on this page to locate upper left corner of
image data in the video frame
5 – X-series Camera Controller
36