Gigabit Ethernet; Microsd; Usb Client; Hdmi Video - FLIR X-Series User Manual

6.2.4 Gigabit Ethernet

6.2.5 MicroSD

Not currently implemented. Reserved for future use.

6.2.6 USB Client

The USB Client is a Command and Control port for user interface, and it can also be used for
firmware upgrades provided by FLIR. This port is USB2 compatible.

6.2.7 HDMI Video

When an HD video mode is selected, this output port is active. It is compatible with standard HDMI
cables.
X-series User's Manual
Gigabit Ethernet (GigE) is a common interface found in most PC's.
The GigE interface can be used for image acquisition and/or
camera control. The GigE interface is GEV/GenICam compliant.
The GigE interface is the only digital data interface that cannot
support the full data rate of the camera.
camera maximum frame rate exceeds the bandwidth of GigE. It
can support up to 30Hz frame rates at full resolution in the X8500-
series cameras, and 125 fps in the X6900-series and X6800-series
cameras at full resolution.
Behind the rubber flap on the back of the X-Series
cameras there is a slot and two connectors as
described below (from top to bottom):
MicroSD Card: This is not currently implemented and
is reserved for future use.
USB Client: The USB Client is a Command and
Control port for the user interface. This connector
also can be used for firmware upgrades provided by
FLIR. This port is USB2 compatible.
HDMI Video: When an HD video mode is selected,
this output port is active.
standard HDMI cables.
6 – Interfaces
This is because the
It is compatible with
74