Advanced User Mode; Status Page - FLIR X-Series User Manual

Internal
External
Abort
Continue
Start

5.4 Advanced User Mode

The Advanced User Mode exposes the full functionality of the camera controller. The controller looks
similar to the basic mode, but additional tabs will appear on each page. This will be the preferred
mode for most users.

5.4.1 Status Page

The Status page is the same in both Basic and Advanced user modes. The Status Page gives general
information about the camera state including camera type, camera time, integration time, frame size,
and frame rate. This page also shows the current IRIG time and the camera operating hours. At the
bottom of the window the detailed camera type is displayed as well as the FPA operating temperature.
The indicator at the bottom left will be green when a connection to a camera is established and will
blink during communication.
X-series User's Manual
Correction Sources
Use the internal flag as the NUC source. The flag is not
temperature controlled and floats at camera internal
Use an external blackbody as the NUC source. Program will
prompt the user to place each source in front of the camera. NUC
source needs to fill the entire field of view.
Correction Process Controls
(will be disabled if command not available)
Stops the NUC process.
When prompted for an action, click "Continue" when action has
been performed.
Starts the selected NUC process.
5 – X-series Camera Controller
26