FLIR X-Series User Manual page 38

NOTE: When using an external frame sync and preset sequencing or superframing, the external
frame sync should be set to comply with ITR frame rate limits. If the external sync rate is too fast, the
camera will ignore syncs that come before the camera is ready
Frame Sync
Preset 0
Integration
Preset 0
Data
Frame Sync
Frame 1 Integration
5.4.2.3.1.1.2 Frame Sync Starts Readout (FSSR)
Upon frame sync, the camera immediately transmits the data from the previous frame.
integration period is then placed to meet ROIC requirements. This mode always operates in IWR
mode. This mode can be used with either internal or external frame sync at full frame rates.
Frame Sync
Frame 1 Integration
5.4.2.3.1.2 Trigger Mode
A sequence consists of a series of frames. In Preset Sequencing, that series of frames can be any
number of any of the four presets. In Superframing, the series is one or zero frames from each
preset. In Single Preset, the series is simply one frame of the selected preset.
X-series User's Manual
Frame Sync
Preset 1
Integration
Preset 1
Data
Frame Sync Starts Integration, ITR
Frame Sync
Frame 2 Integration
Frame 1 Data
Frame Sync Starts Integration, IWR
Frame Sync
Frame 2 Integration
Frame 1 Data
Frame Sync Starts Readout
Frame Sync
Preset 2
Integration
Frame Sync
Frame 3 Integration
Frame 2 Data
Frame Sync
Frame 3 Integration
Frame 2 Data
5 – X-series Camera Controller
Frame Sync
Preset 3
Integration
Preset 2
Data
Frame Sync
Frame 4 Integration
Frame 3 Data
Frame Sync
Frame 4 Integration
Frame 3 Data
Preset 3
Data
The
38