6.3 Breakout Connector Cable
The PTZ-35 MS / PTZ-50 MS camera also includes a breakout cable (as shown in Error! Reference
source not found.) that connects to the integrated interface cable with single terminal connectors. The
breakout cable has the MIL-C-26482 Series 1 Connector (Female) on one end and five pig-tail leads,
described as follows:
One lead is used for power and the pin outs are shown here.
Input voltage range: 24 VDC ±10 % with 24 VDC optimum value
Figure 17: Fisher 103-A032 (Female) on Break-out Connector
Two leads are for the IR and DLTV video as shown here:
Figure 18: IR Video Output
Finally, two leads for serial communication are provided as shown here:
5 4 3 2 1
9 8 7 6
Figure 20: RS-232 DB-9 (Female)
RS-232 DB9 Socket
COM 1 Tx
COM 1 Rx
COM 1 GND
3
Some RS-422 and RS-485 equipment manufacturers designate the "-" signal as "A" and the "+" signal as "B".
427-0116-00-10 Revision 130
Pin 2
Pin 3
Pin5
Figure 19: DLTV video output
1 2 3 4 5
6 7 8 9
Figure 21: RS-422 DB-9 (Male)
RS-422 DB9 Pin
3
COM 3 Tx (+)
COM 3 Tx (-)
COM 3 Rx (+)
COM3 Rx (-)
Note: With RS-422 communications, the transmit
(Tx) connections from the camera go to the receive
(Rx) connections at the other end, and vice versa.
Copyright © 2010 FLIR Systems, Inc.
Pin 8
Pin 9
Pin 6
Pin 7
24