Table of Contents
Advertisement
6.3
Interface Connector
6.3.1
Ethernet Connector
The 8-pin RJ-45 Ethernet jack is equipped with two (2) M2 screwholes for secure connection. Pin assignments conform
to the Ethernet standard.
6.4
Interface Cables
To purchase a recommended cable from FLIR, visit the
Category 5e cables up to 40 meters in length can be used with 10 GigE. For cable lengths greater than 40 meters,
Category 6a cables should be used. sells Category 5e cables.
6.5
Interface Card
To purchase a compatible card from FLIR, visit the
The camera must connect to an interface card. This is sometimes called a host adapter, a bus controller, or a network
interface card (NIC).
A 10G BASE-T NIC is recommended for streaming images on the Ethernet network between the camera and host
system.
FLIR sells a compatible card (PN: ACC-01-1101) available from our
6.6
General Purpose Input/Output (GPIO)
The camera has an 12-pin GPIO connector on the back of the case.
See
Input/Output Control
4/9/2020
©2015-2020 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
Note: For optimal ESD protection, we recommend using a shielded
Ethernet cable or connecting the camera housing to chassis ground
(earth).
Products Accessories
Note: For optimal video streaming and camera control
performance, we recommend an Intel Pro chipset on a PCIe
interface.
for details on pin assignments and electrical characteristics.
FLIR Oryx
Products Accessories
page.
page.
Products Accessories
®
Installation Guide
6 Oryx Physical Interface
page.
18
Advertisement
Table of Contents
