Equipment Required; Device Connections - Keithley 4200A-SCS User Manual

Section 7: PMU for pulsed I-V measurements on a MOSFET

Equipment required

•
One 4200A-SCS with the following instruments:
▪
One 4225-PMU
▪
Two 4225-RPMs
•
Two CA-547-2A RPM interconnect cables (supplied with the 4225-RPM)
•
Two CS-712 male triaxial to female BNC adapters, guard removed (supplied with 4225-RPM)
•
Two CS-1247 male BNC to female SMA adapters (supplied with the 4225-RPM)
•
Two CA-452A SMA to SMA cables (supplied with the 4225-RPM)
•
Two 4200-PRB-C SMA to SSMC Y adapter cables

Device connections

Using the supplied cables, make connections from the output terminals of the two 4225-RPMs to the
MOSFET.
Hazardous voltages may be present on all output and guard terminals. To prevent electrical
shock that could cause injury or death, never connect or disconnect from the 4200A-SCS
while the output is on.
To prevent electric shock, test connections must be configured such that the user cannot
come in contact with test leads, conductors, or any device under test (DUT) that is in contact
with the conductors. It is good practice to disconnect DUTs from the instrument before
powering up the instrument. Safe installation requires proper shields, barriers, and grounding
to prevent contact with test lead and conductors.
7-2
Model 4200A-SCS Pulse Card (PGU and PMU) User's Manual
4200A-PMU-900-01 Rev. A December 2020