Configure The Cv-Diode Test - Keithley 4200A-SCS User Manual

Section 6: Use the RPM to switch the SMU, CVU, and PMU Model 4200A-SCS Pulse Card (PGU and PMU) User's Manual

Configure the cv-diode test

To configure the cv-diode test:
1. Select the cv-diode test from the project tree.
2. Select the Anode terminal of the diode in the Key Parameters pane
3. Adjust the voltage source and test frequency settings as needed.
Figure 133: Key Parameters pane for the cv-diode sweep test
4. On the Test Settings pane, select Advanced. Adjust the timing parameters as needed. Be sure to
include the sweep delay time in your adjustments.
6-10 4200A-PMU-900-01 Rev. A December 2020