Power On And Off Sequence; Powering On - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
Keep the rear cover of the TeamPoS 2000 terminal installed at all times unless the
terminal is being serviced. The cover protects the cable connections and ensures
adequate clearance for proper ventilation.
Make sure all cable connectors are securely installed on the terminal and peripherals to
prevent the cables from being accidentally pulled off. Disconnecting and connecting
cables (except USB cables) to the terminal while the power is on could cause damage
to the terminal and its peripherals.
Do not expose the terminal to liquids. Although the units are designed to prevent
liquids from entering the internal components, liquids should be kept away from the
terminal.

6.1.2 Power ON and OFF Sequence

This section presents the general procedures for powering the TeamPoS 2000 control unit
ON and OFF. The instructions in this section assume that the terminal, operating system,
and the application software have been installed. For any additional power on and off
procedures dictated by the retail application, refer to the manuals provided with your
PoS and application software.
Caution: With the exception of USB peripherals, never remove or

6.1.3 Powering ON

1. Make sure all peripherals are securely connected to the control unit.
2. Make sure the power cord is plugged into the power source.
3. Lift the plastic switch cover at the front of the control unit.
4. Press the ON switch.
5. Confirm the power/battery status LED is ON and not blinking, indicating the
successful completion of power-up diagnostics.
6-2
connect any peripheral while power is on its port. To avoid
damage to the control unit and peripherals, when connecting and
disconnecting peripherals from the Retail I/O or TeamCOMBO
Board's RS232 ports, turn power OFF with the ports OFF switch,
the TeamPoS 2000 power switch (in the front of the unit) or by
disconnecting AC power.
Rev 3.0
MAINTENANCE MANUAL
90000291