Teampos 2000 Front Panel Switch And Lcd Matrix - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000

1.2.1 TeamPoS 2000 Front Panel Switch and LCD Matrix

Name Switch/LED
Power SW
Reset SW
Dump SW
(DO NOT USE)
Port On/Off SW
HDD Select SW
Power LED
Port On LED
Battery Backup LED
HDD Access LED
LAN Activity LED
Caution: It is assumed that the user of this manual fully understands and strictly
1-4
Mounting LED Color Remark
Position
Outside of —
Front Door
Inside of Front —
Door
Inside of Front —
Door
Inside of Front —
Door
Inside of Front —
Door
Outside of Green
Front Door
Outside of Green
Front Door
Outside of Blinking
Front Door Yellow
Inside of Front Green
Door
Inside of Front Green
Door
adheres to proper Electrostatic Discharge (ESD) precautions. Failure to
adhere to precautions can cause damage to this equipment.
Always remove the power cord from the unit prior to performing any
controller maintenance.
Depending on BIOS setup, the power switch can be
instant off or delayed off.
PC board resets.
Resets CMOS memory on Retail I/O,TeamCOMBO®
or TeamUSB® Board.
Interrupts power to the I/O board's RS232 ports and the
LCD power port. (For the original TeamCOMBO board,
the switch also interrupts power to USB ports on the
TeamCOMBO board. For the revised TeamCOMBO
board, the switch interrupts power only for the RS232
and LCD power ports.)
Selects master HDD between primary and secondary
HDD. The hard drives must be jumpered to Cable
Select (CS) in order to allow switching of disks.
This LED is illuminated when power is supplied
including during battery backup mode. It blinks when
power switch is pressed in delayed off mode.
This LED is illuminated when the port on/off switch is
set to on.
This LED is turned on and blinking when the power is
supplied from lead-battery (i.e., when battery backup is
enabled due to AC power loss.).
Indicates hard disk access activity.
Illuminates with LAN activity.
Rev 3.0
MAINTENANCE MANUAL
90000291