Installing D12 And A12 Lcd Brackets - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000

5.1.5 Installing D12 and A12 LCD Brackets

5.1.5.1 Installing keyboard, printer, CRT and LCD brackets
For stacked configurations, keyboard, printer and operator display brackets are available.
The brackets attach to the top of the control unit and restrain the peripherals from sliding.
The following table shows available brackets for the compact and standard control units:
When installing peripheral brackets, install each bracket using two screws that have been
provided with the bracket. For most installations, a keyboard, printer and display bracket
will be required.
Note: See bracket options in Chapter 10 for part numbers.
Bracket
Keyboard
FD20/21 Printer
Axiohm A758
Printer
DT50/DT50II/
DT50IIT
Printer
D12/A12 LCD
CRT
Note: When installing mounting screws, do not over-tighten.
Installing the brackets merely requires placing the bracket on the appropriate screw holes
and securing with two screws provided for each bracket. To prevent dust and moisture
penetration, apply a screw-hole cover label from the provided label sheet over each screw
90000291
Compact Standard
Yes
Yes
No Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
Rev 3.0
MAINTENANCE MANUAL
Mutually Comments
exclusive with
Fits Models 133UQ,
133PQ, 136P and
104P keyboards
All other printer
brackets
All other printer
brackets
All other printer When stacking the
brackets DT50/DT50II/
DT50IIT and a
D12/A12 LCD on a
standard unit, a
CRT filler and shorter
connector cover are
optional
LCD
5-7