Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 144

TeamPoS 2000
5. Remove the PC board.
6. Insert the replacement PC board with the plastic rails (underside the motherboard),
into the rail guides on the chassis.
7. Insert the PC board with the lever at 90° to chassis, until it meets the mating connector
(nearly fully inserted). Use the lever to fully seat the motherboard.
8. Reconnect all peripheral cables that were connected to the PC board.
9. On completion of insertion, attach the left side cover to the equipment, by sliding back
and locking into place. Also, reattach the front cover.
10. The system CMOS must be set after replacing the PC board. Be sure to execute the
BIOS setup operation on the BIOS setup screen. (For BIOS setup procedures, see
Chapter 8, "BIOS Setup Procedures.")
11. If this replacement is an upgrade, install the upgrade label that comes with the PC
Board upgrade kit on the side of the unit near the serial number (see section 5.2.1).
7-4 Rev 3.0
MAINTENANCE MANUAL
90000291