Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 84

TeamPoS 2000
8. Insert the media player through the front opening with the
ribbon cable and audio cable. See photo on opposite page.
Ensure guides on left hand side of media player align above
chassis guides.
9. Route the audio cable under the floppy disk ribbon cable,
which is attached to the riser card, and connect to the
audio connector on the riser card. Use the audio cable
retainer. Check that the cable will not interfere with the
removal of the PC-board.
10. Bend the media player ribbon cable to form a 90º angle
and install on the riser card connector.
11. Locate the media player power connector. It is one of the
power supply unit's wiring harnesses. Cut the tie wrap
and connect the Media Player power connector to the
media player. It is polarized, so make sure it is installed
correctly.
12. Push the media player completely into the controller
ensuring that it is level and the mounting hole matches the
mounting bracket. Secure with the mounting screw.
13. Re-install the Retail I/O, TeamCOMBO or TeamUSB
board and covers.
14. Remove filler in front cover to allow access to the media
player.
15. Once all covers have been reinstalled, verify the media player's disk tray will open
properly by use of the manual tray release. Adjust front panel if disk tray sticks.
16. When installing media player, ensure that the upgrade label that comes with the media
player upgrade kit is applied to the side of the control unit (see section 5.2.1)
5-28 Rev 3.0
MAINTENANCE MANUAL
90000291