Table of Contents
Advertisement
TeamPoS 2000
2.
Turn the D15 faceup on the counter and using a flat
head screw driver, gently pry off the right side
frame of the D15. Insert the the small white
connector into the port on the D15.
3.
Line up the metal brace and insert the edge in the
grooved channel. Orient the D15 so that the end
opposite the keypad is against your body. Lean to
one side to view the slot. Slip just the edge of the
metal keypad brace into the slot. Using a flat head
screw driver pry up one end of the grooved panel
and ease it over the top edge of the D15.
Maintaining a steady pressure, slide the
screwdriver along the edge until the entire cosmetic
front panel slips over the front edge of the panel
and push the keypad into place. The grooved,
cosmetic panel covers the edge where the frame was removed.
4.
Turn the D15 over to the back side and secure the keypad with 3 screws provided with
the keypad. Snap on the back panel.
5.9.7.5
SmartPoSKeyPad & MSR Installation
The keypad and MSR come together in the kit. Follow the directions for the keypad
installation.
5.9.7.6
VF50U Stacked Customer Display Installation
1.
As with the D15 installation, the VF50U display
begins with the installation of the stacking plate onto
the top of the TP2K using thirteen M3 x 5 Phillips
Flat Head screws.
90000291
MAINTENANCE MANUAL
Rev 3.0
5-51
Hide quick links:
Advertisement
Table of Contents
