Bios Error Messages - M Motherboard - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
8.2

BIOS Error Messages - M Motherboard

If BIOS finds an error during a power-ON self-test (POST), an audible beep code is
emitted and a message is displayed.
When the message is displayed, the following is also displayed: "PRESS F1 TO
CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP"
If BIOS detects an error during the POST, one or more messages shown below are
displayed:
Error Name
Channel 2 timer error
CMOS battery failure
CMOS system options net set
CMOS checksum error
Keyboard locked
Keyboard not functional
Keyboard controller not functional
CMOS memory size different
Memory decreased in size
Cache Memory Error
Flooppy drive 0 error
Floppy controller error
CMOS time not set
Number of ATA drive reduced error
DDC Monitor Configuration Change
3.3V out of range and the value
+5V out of range and the value
-5V out of range and the value
+12V out of range and the value
-12V out of range and the value
8-34
Meaning
Error of 8254 Timer
CMOS battery test fail
T.B.D.
CMOS checksum test error
When key islocking during boot
There is no keyboad during boot however in Headless
mode it can be bypass
KB control test fail.
When BIOS uses other than "Base Memory: 64KB,
Extend memory: 1MB"
DIMM Memory size decrease from the previous boot
in the system during boot time.
When Floppy drive is enabled, floppy drive cannot
work well.
Floppy control test fail.
The time of RTC does not set
Number of ATA Device decrease from the previous
boot in the system during boot time.
System board device resources conflict.
+3.3 voltage out of limit
+5 voltage out of limit
-5 voltage out of limit
+12 voltage out of limit
-12 voltage out of limit
Rev 3.0
MAINTENANCE MANUAL
90000291