Powering Off - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
Any hardware errors detected on power up will appear on the operator display (CRT or
LCD). Note that the Model VF50 two-line alphanumeric display does not display error
messages.
Note: Some peripherals, such as scanners and scales, may be separately powered.
Check the peripheral manuals for instructions for these peripherals.

6.1.4 Powering OFF

1. Lift the plastic switch cover.
2. Press the ON/OFF switch.
Note: Depending on BIOS setup, a momentary depression of the switch may signal the
application to shut the unit down, which could take a few minutes. If power is
not immediately turned off, either wait for the application to shut the unit down,
or keep the switch depressed for approximately 4 seconds. For proper shutdown
procedures, see the application software documentation.
90000291 Rev 3.0
MAINTENANCE MANUAL
6-3