Table of Contents
Advertisement
TeamPoS 2000
7.13
Retail I/O, TeamCOMBO and TeamUSB Board Replacement
1.
Remove the AC power.
2.
Remove the front cover (see section 5.1.1).
3.
Remove the top cover (see section 5.1.4).
4.
Remove the two Philips screws, and then lift Retail I/O, TeamCOMBO or TeamUSB
board to remove it from the connector on the riser card. Pull board up until connector
on riser is free. More upward pressure is required on the riser card side.
5.
To mount the Retail I/O, TeamCOMBO or TeamUSB board again, reverse the
removal procedure.
6.
When either the TeamCOMBO board or the TeamUSB board is installed, one of the
USB ports on the A motherboard becomes unavailable because it is used as a hub for
the new I-O board. Install a blanking label, provided with the Upgrade Kit over the
top USB port connector on the back of the motherboard.
90000291
Rev 3.0
MAINTENANCE MANUAL
7-23
Hide quick links:
Advertisement
Table of Contents
