A Motherboard Settings - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
7.4

A Motherboard Settings

No. Pin
Name
JP0601
1
JP0301
2
3 JP0302
JP0303
JP0701
4
JP1501
5
JP2402
6
Note: Coppermine is also referred to as 0.18mm technology. The 600 and 800 MHz
and 1GHz Pentium III and 566MHz Celeron incorporate Coppermine technology.
Mendocino is also referred to as 0.25mm technology. The 433MHz Celeron
incorporates Mendocino technology.
Note: When power is OFF and then turned ON:
1. POS mode boots up automatically.
2. General PC Mode stays OFF until turned ON by power switch
3. AC-ON mode is not used.
7-10
Meaning
CPU frequency multiplier - Not Used
See 1st note below.
Select either Pentium III or Celeron. (Voltage setting)
Jumper 1-2: Pentium III and 566 MHz Celeron
(Coppermine core)
Jumper 2-3: Celeron 433 (Mendocino core)
Select either Coppermine or Mendocino CPU
SHORT: Pentium III & 566 MHz Celeron (Coppermine core)
OPEN: 433 MHz Celeron (Mendocino Core)
SHORT: Pentium III & 566 MHz Celeron (Coppermine core)
OPEN: 433 MHz Celeron (Mendocino Core)
Deleting the CMOS RAM password
1-2: Normal
2-3: Password deleted
Keyboard/mouse power sources
1-2: Normal 5 V system
2-3: Standby 5 V system (Default Test Only)
See 2nd note below.
DC output mode at AC input (see note 2 that follows)
5-6, 2-3: POS mode
4-5, 2-3: General PC mode
5-6, 1-2: AC_ON mode (not used)
Rev 3.0
MAINTENANCE MANUAL
Default
Settings
1-2 Short
3-4 Open
5-6 Open
7-8 Open
Depends on
CPU
Depends on
CPU
1-2
1-2
5-6, 2-3
90000291