Printer Jumpers - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
Switch Definition
SW1 COM3 IRQ
Only one IRQ switch can be ON
Note: Only applies when SW 3, position 4 is
set for COM 3/4
SW2 COM4 IRQ
Only one IRQ switch can be ON
Note: Only applies when SW 3, position 4 is
set for COM 3/4

5.3.3 Printer Jumpers

There are two printer jumper connectors, one is FJ and used for the models FD20 and
FD21 printers. The other is ESC/POS (default) and is used for all other supported
printers. Depending on the printer being connected, place the jumper block so that all
pins on the appropriate connector are shorted
The following tables contain the connector signals for the ports on the Retail I/O Board.
A diagram of each connector and its pin out locations is shown after each table.
5-14
FJ
Mux12 +5V
Mux11 +5V
Mux9 Not used
Mux6 Not used
Mux5 GND
Mux4 GND
Mux1 RESET
Rev 3.0
MAINTENANCE MANUAL
Settings (Default in Bold)
IRQ3 OFF
IRQ4 ON
IRQ9 OFF
IRQ3 ON IRQ10 OFF
IRQ4 OFF IRQ11 OFF
IRQ9 OFF IRQ12 OFF
ESC/POS
RTS
DTR
RI
CD
DSR
CTS
GND
IRQ10 OFF
IRQ11 OFF
IRQ12 OFF
90000291