Hdd Kit Replacement - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
7.7

HDD Kit Replacement

Caution: To prevent electric shock, confirm that the AC cable is removed from
1. Remove the front cover (see section 5.1.1).
2. Remove the metal EMI shield from the front of the hard disk unit.
3. Disconnect the power and signal cables from the applicable hard disk, pull the black
pull cord (indicated by the arrow in the figure below), pulling the hard disk out.
The HDD kit has setting pins similar to connector shown on the following page. Make
sure the jumper settings on the new drive match before replacing with the new HDD.
Caution: Ensure replacement drive settings match the settiongs of the removed
7-14
the AC outlet anytime the covers are removed. Be sure to observe all
ESD precautions and power off procedures.
drive
Rev 3.0
MAINTENANCE MANUAL
90000291