6.1.2 Power On And Off Sequence - Fujitsu TeamPoS 3000 XT Installation & Maintenance Manual

TeamPoS 3000XT
6. Make sure all cable connectors are securely installed on the terminal and
peripherals to prevent the cables from being accidentally pulled off.
Disconnecting and connecting cables (except USB cables) to the terminal
while the power is on could cause damage to the terminal and its
peripherals.
7. Do not expose the terminal to liquids. Although the units are designed to
resist liquids from entering the internal components, liquids should be kept
away from the terminal.

6.1.2 Power ON and OFF Sequence

This section presents the general procedures for powering the TeamPoS
3000XT control unit ON and OFF. The instructions in this section assume
that the terminal, operating system, and the application software have been
installed. For any additional power on and off procedures dictated by the
retail application, refer to the manuals provided with your PoS application
software.
Caution: With the exception of USB peripherals, never remove or
6-2
connect any peripheral while power is on its port. To avoid
damage to the control unit and peripherals, when connecting and
disconnecting RS232 peripherals, turn power OFF with the ports
OFF switch, the TeamPoS 3000XT power switch (on the left side
of the unit) or by disconnecting AC power.
Installation and Maintenance Manual
D900000172