5.5
HEPA Cartridge replacement (if provided)
To replace the HEPA cartridge, operate as follows:
-
Switch the vacuum off
-
Disconnect the vacuum cleaner from the electricity supply
-
Unlock the two filter H strip closing hooks on both sides from the vacuum cleaner head
-
Remove the head
-
Unlock the two filter chamber closing hooks on both sides from the filter H strip
-
Remove the filter H strip, turn it upside down on a work bench and unscrew the HEPA
cartridge fastening screws and remove it from its slot
To re-assemble the HEPA cartridges, operate in reverse:
-
Position the new HEPA cartridge in its slot and tighten the fastening screw provided. Ensure
that it is properly secured
-
Replace the filter H strip on the filter chamber and lock it with the special closing hooks
-
Place the vacuum cleaner head above the filter H strip and lock it with the special closing hooks
-
connect the vacuum cleaner to the electricity supply
-
turn on the vacuum cleaner, immediately assessing its normal operation
EXCLUSIVELY USE FILTERS MANUFACTURED BY DEPURECO
remove the filter, put it in a plastic bag, seal it and dispose of it according
to the applicable legislation on the type of material collected.
Pag. 37 di 44