4. Ground transmitter via grounding terminal (PE) on PCB.
5. Tighten both transducer cable glands.
6. Make sure that transducer cables are not overbent. Minimum cable bend radius is 50
5.2
Wiring the power supply and the output
The wiring of the power supply and the output is done in three steps:
1. Wiring the power supply
2. Wiring the pulse output (if relevant)
3. Mounting the transmitter
5.2.1
Wiring the power supply
Make sure the power supply requirements stated on the nameplates are met!
SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
Note
Sensor grounding
To ensure identical potential for sensor and transmitter, a direct grounding of transmitter
and sensor is recommended.
mm.
WARNING
5.2 Wiring the power supply and the output
Connecting
25