Application label
The application label is supplied with the device and can be used to show the local
application settings of the transmitter. It is recommended to fill in this label with the
application values and place it on the left side of transmitter.
Figure 1-2
1.2
History
The contents of these instructions are regularly reviewed and corrections are included in
subsequent editions. We welcome all suggestions for improvement.
The following table shows the most important changes in the documentation compared to
each previous edition.
Edition
07/2012
The documentation of this edition is applicable for the firmware stated in the table.
Note
A flowmeter system consists of a sensor retrofit kit (SONOKIT) and a transmitter (FUS080).
These Operating Instructions only cover the transmitter part of the system. The sensor part
has a separate manual, which is available on the SITRANS F US literature CD-ROM and on
the flowdocumentation website (http://www.siemens.com/flowdocumentation)
SITRANS FUS080 transmitter
Operating Instructions, 07/2012, A5E03059912-02
Application label
Remarks
First edition
FW version
EDD version
2.03
01-02-07
Introduction
1.2 History
9