Logfile Commands - Adaptec RAID 21610SA Installation And User Manual

Switches
/repair—If FALSE (the default), the command only reports
failures. If TRUE, bad blocks are automatically repaired, if
possible.
/wait— If FALSE (the default), the operation is performed in the
background and the command prompt is returned immediately.
If TRUE, the operation is performed immediately and the
command prompt is returned only when done.
disk zero [/repair={boolean}] [/wait={boolean}]
{device_ID}
Clears an entire disk (by writing zeros). All data is erased and
cannot be recovered.
Parameters
{device_ID}—ID of the device to clear.
Switches
/repair—If FALSE (the default), the command only reports
failures. If TRUE, bad blocks are automatically repaired, if
possible.
/wait— If FALSE (the default), the operation is performed in the
background and the command prompt is returned immediately.
If TRUE, the operation is performed immediately and the
command prompt is returned only when done.

Logfile Commands

logfile end
Ends logging of all output and closes the log file.
logfile start [/append={boolean}] {file}
Begins logging of all CLI command line activity to a file.
Parameters
{string}—Name of log file.
Switches
/append—Specifies whether to append all CLI command line
activity to an existing output file if one exists.
Command Line Interface (CLI)
C-32