Adding The Driver To An Existing System - Adaptec RAID 21610SA Installation And User Manual

Adding the Driver to an Existing System

In this scenario, you are adding the driver to an existing Windows
system. To install the driver:
1 Install and configure the controller and hard disk drives
according to the instructions in
2 Start Windows. Windows launches the Found New Hardware
Wizard, which searches for the controller driver.
3 Insert the driver disk, select the floppy drive as the source and
then click Next.
4 Click Next in the succeeding two windows that appear and
follow the on-screen instructions to complete the controller
installation.
5 Remove the driver disk and restart the system.
Chapter 2.
Installing the Driver
3-4