Unixware And Openunix; Installing The Driver On A New System; Adding The Driver To An Existing System - Adaptec RAID 21610SA Installation And User Manual

UnixWare and OpenUNIX

Although the driver disk you create for UnixWare 7.1.1 and
OpenUNIX 8 differ, the installation procedures for these operating
systems are the same.

Installing the Driver on a New System

In this scenario, you are installing the controller in a new
UnixWare 7.1.1 or OpenUNIX 8 system.
To install the driver:
1 Install and configure the controller and hard disk drives
according to the instructions in
Early in the operating system installation, you are shown a
window labeled
2 Insert the driver disk, select Install HBA diskette and then
press F10.
The driver loads from the driver disk. Then, the HBA screen is
displayed.
3 Select Proceed with Installation and then press F10.
4 Complete the installation as appropriate.
5 When the installation is finished, remove the driver disk and
restart the system.

Adding the Driver to an Existing System

In this scenario, you are adding the driver to an existing
UnixWare 7.1.1 or OpenUNIX 8 system.
To install the driver:
1 Shut down the computer. Install and configure the controller
and hard disk drives according to the instructions in
2 Turn on the computer. Then, insert the driver disk.
3 To run the
pkgadd
press Enter. UNIX reads the disk and package information.
4 Press Enter.
5 Restart the system. The system rebuilds the kernel automatically.
6 Add devices to the controller.
Choose One.
utility, type pkgadd -d diskette1 and then
Chapter 2.
Installing the Driver
Chapter 2.
3-7