Table of Contents
Advertisement
Adaptec Storage Management Software User's Guide
Array and Array Group Information
The Information tab for any array may be viewed by highlighting
that array, as shown in Figure 2-8.
Figure 2-8 Array Group Information Tab
RAID 0 arrays are comprised of any number of drives greater than
1. RAID 1 arrays are comprised of a pair of drives. RAID 5 arrays
contain three or more drives.
After you create the arrays, one or more arrays of the same RAID
level can be combined into a multilevel RAID (see
Multilevel RAID on page
RAIDs by the controller firmware. All the drives in an array or
multilevel RAID must be attached to the same controller, and
appear to the host as a single Logical Storage Unit (LSU).
Note: Arrays do not start building until a Set System Config
action has been performed.
The Array Information tab displays general array information and
hardware configuration. It is divided into three parts: Description,
SCSI Capabilities, and Status.
2-18
2-23). Arrays are striped into multilevel
Creating a
Advertisement
Table of Contents
