Table of Contents
Advertisement
Adaptec Storage Management Software User's Guide
followed by a drive address as discussed in Device Address Syntax
on page 4-2.
Multiple drive addresses on a command line must always be
separated by commas.
This switch can also be used to introduce a list of comma-separated
drive addresses in any command that uses such addresses. When
creating multilevel RAID10 or 50 arrays, separate drive groups
with a plus sign (+). The number of drives supported are listed
below:
RAID 0
RAID 1
RAID 5
Logical Drive Creation and Deletion
-c, -d Specify controller ID
This switch specifies the RAID controller to which all subsequent
parameters will apply. It is required for all operations. You can
specify a device which is attached to the controller, from which the
controller number will be derived, or you can enter the relative
controller number directly.
Use –c to specify the controller using the ID assigned to the
■
controller by your operating system.
Use –d to specify the controller ID in BIOS format. Adaptec
■
controllers are numbered starting from 0 according to their PCI
slot location. The boot controller or the controller in the lowest
number PCI slot is ID d0.
4-4
2 to 64 drives
2 to 64 drives (as pairs)
3 to 64 drives
Advertisement
Table of Contents
