Table of Contents
Advertisement
Adaptec Storage Management Software User's Guide
Events
Events are generated for detected fault conditions as well as RAID
status changes, and are described as follows:
Soft Error
Recoverable
Hard Error
Nonrecoverabl
e Hard Error
Status Change
Event Log
When events occur, they are automatically logged in the cache on
the RAID controller where they occurred. In addition, you can
specify that Storage Manager maintain an event log on disk (see
Event Broadcaster on page
log, click Event Log in any controller, drive, or array information
window. Only the events reported for the selected device or array
are displayed.
3-32
An operation on a hard drive that caused an error,
but was successful after a retry.
An error on a hard drive, controller, or peripheral
bus, where the data was recovered using ECC or
from redundant array information.
An error on a hard drive, controller, or peripheral
bus where the data could not be recovered using
ECC or from redundant array information.
The status of an array or drive changed. Examples of
this would be a drive or array failure, or an array
build or rebuild operation that was initiated or
completed.
3-34). To display the contents of the event
Advertisement
Table of Contents
