Commissioning; Maintenance; Product Disposal; Further Information - Nice Filo Instructions And Warnings For Installation

6.2 - COMMISSIONING

Commissioning can only be performed after all test phases have been successfully completed. Partial or "makeshift" commissionin
is strictly prohibited.
01.
Fig. 8), risk analysis and relative solutions adopted, the manufacturer's declaration of conformity for all the devices used.
02.
missioning"), serial number, year of construction and "CE" marking.
03. Permanently attach to the gate the label supplied in the pack, regarding the procedure for manual locking/release of the gearmotor.
04. Fill in the declaration of conformity and hand it to the owner of the automation (Annex 1).
05. Draw up and hand to the owner of the automation the user guide (Chapter 11 – detachable insert).
06.
07. Before commissioning the automation, ensure that the owner is properly informed of all risks and hazards still present.
7

MAINTENANCE

Maintenance must be performed in strict observance of the safety provisions in this manual and according to current legislation
standards.
8

PRODUCT DISPOSAL

This product is an integral part of the automation and therefore must be disposed together with the latter.
This product is made of various types of materials, some of which can be recycled while others must be scrapped. Seek information on the recycling
– certain parts of the product may contain polluting or hazardous substances that, if released into the environment, may seriously damage
the environment and human health.
As indicated by the adjacent symbol, the product may not be disposed of together with domestic waste. Separate the waste into categories for dis
posal, according to the methods set out by legislation in force in your area, or return the product to the retailer when purchasing a new
version.
9

FURTHER INFORMATION

9.1 - ADVANCED SETTINGS
9.1.1 - Adjusting the parameters (using the transmitter memorised in mode 1)
time during which the gate remains open before re-closing automatically (if the "automatic closing function is set).
• partial opening mode of the gate, to allow pedestrians to pass through.
• SbS Function
• OGI (
The adjustment can be e ected by means of any transmitter
memorised in Mode 1, it is possible to memorise one solely for programming purposes then cancelling it (see Paragraph 9.4).
the safety system or damage the gate itself.
EN 12453 standards.
• Weather conditions may a ect the movement of the gate, so the latter should be readjusted periodically.
Adjustment procedure
01. On the transmitter (Fig. 25 ) simultaneously press and hold keys T1 and T2
02. Within 3 seconds from releasing them, perform the action speci ed in Table 2 to modify the desired parameter.
03. Whenever the desired key is pressed, the ashing light emits a ash.
9 – English
output to which it is possible to connect a 24 V maximum 4 W warning light.
memorised in Mode 1 (as those supplied, see Paragraph 9.3.1). If there is no transmitter
for 5 seconds then release them.
g
-
and
-
-
with the