Programming; Control Unit Keys; Initial Checks; Memorisation Of Connected Devices - Nice Filo Instructions And Warnings For Installation

5

PROGRAMMING

5.1 - CONTROL UNIT KEYS

and
P1 = Step-by-Step command
P2 = slow/fast movement speed
P3 = semi-automatic/automatic
5.6.2)
P4 = radio transmitter memorisation
5.2 - PRELIMINARY CHECKS
01. Depending on the gearmotor's installation position ( to the right or left of the gate), shift the selector as shown in
opening direction.
02. Check on the control unit
02. On the Tx and Rx photocells
it is important that the led is not always o or always lit.
03. If all these checks are non-conforming, disconnect the power supply to the control unit and check the relevant connections of the cables. Other
useful information is contained in Chapters 9.9 and 10.
13
14
T
Fuse 1.6A T Fus
Aeri al Aerial
L4 L 4
P4 P4 P3 P3

5.3 - MEMORISATION OF CONNECTED DEVICES

On completion of the preliminary checks (Par. 5.2), the control unit must be made to recognise the devices connected on the
terminals.
01. On the control unit (Fig. 16 ) press and hold button P2 for at least 3 seconds then release it.
02. Wait a few seconds for the control unit to complete the device learning phase.
03. On the control unit (Fig. 17 ), at the end of the recognition procedure, the Stop led must remain lit and led L2 must turn o . The ECSBus led
the learning procedure for the connected devices.
Step
(Fig. 12 )
selection (Par. 5.6.1)
operating cycle selection (Par.
(Fig. 14 ) that the ECSBus led
(Fig. 15 ) check that the SAFE led
Flash sh
Flash
OG I OG I
OGI
ECSbus
ECSbus
Stop
Stop Stop
Sb S
Sb S bS
L1 L1 1
Sb S S bS
P2 P 2 P1 P1
led L2
D
12
Aer ial Aerial
15
OGI OGI
ECSbus E CS bus
Stop S top
Sb S S bS
L4 L3 L2 L1
Sb S
P4 P3 P2 P1
Fig. 13 to determine the gate's
TX RX
led
SAFE
ECSBus and Stop
English – 6