Advanced Adjustments; Adjusting The Parameters Using The Transmitter; Presence Function; Verifying The Values Set For Each Parameter Using The Transmitter - Nice Filo Instructions And Warnings For Installation

Parameters Value
Pause time 10 sec
20 sec *
40 sec
60 sec
Pedestrian
opening
Gate open to 1 m *
Motor force Low
Medium-low *
Medium-high
High
Step-by-Step Open - Stop - Close - Stop
(SbS)
Open - Stop - Close - Open *
function
Open - Close - Open - Close
Opening only
OGI (Open Gate OGI *
Indicator)
30 sec courtesy light
function
60 sec courtesy light

Presence function

* Factory value
9.1.2 - Presence function
This function is regulated by key T5
- with the gate closed
object, the courtesy light switches o .
- with the gate moving (opening and closing manoeuvre)
mains lit for a further 5 seconds.
- with the gate open and automatic closing
and follows the gate' s behaviour when closed.
- with the gate open and automatic closing
follows the gate' s behaviour when closed.
If the OGI function is active
- o
- slow ashing
- fast ashing
- steady lit
9.1.3 - Verifying the values set for each parameter (using the transmitter memorised in mode 1)
The check can be e ected by means of any transmitter
rised in Mode 1, it is possible to memorise one solely for programming purposes then cancelling it (see Paragraph 9.4).
Adjustment procedure
01. On the transmitter (Fig. 24 ) simultaneously press and hold buttons T1 and T2
02. Within 3 seconds from releasing them, perform the action speci ed in Table 3 to verify the desired parameter.
03.
TABLE 3
Parameters Actions to be performed
Pause time Press and hold key T1
Pedestrian opening Press and hold key T2
Motor force Press and hold key T3
S bS function Press and hold key T4
OGI function Press and hold key T5

9.2 - ADDING OR REMOVING DEVICES

FILO 400C/FILO 600C

9.2.1 - Memorising additional devices

TABLE 2
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
not active
active
memorised in Mode 1 (as those supplied, see Paragraph 9.3.1). If there is no transmitter memo
count the ashes . Check in Table 2 the value corresponding to the number of ashes.
Transmitter key to be Actions to be performed
used
T1 Press T1 once
T1 Press T1 twice
T1 Press T1 three times
T1 Press T1 four times
T2 Press T2 once
T2 Press T2 twice
T2 Press T2 three times
T2 Press T2 four times
T3 Press T3 once
T3 Press T3 twice
T3 Press T3 three times
T3 Press T3 four times
T4 Press T4 once
T4 Press T4 twice
T4 Press T4 three times
T4 Press T4 four times
T5 Press T5 once
T5 Press T5 twice
T5 Press T5 three times
T5 Press T5 four times
for 5 seconds then release them.
24
it is important to verify that these are perfectly compatible with
-
-
1
2
-
English – 10