Deleting The Memory Of The Individual Transmitter From The Control Unit's Memory; Complete Deletion Of The Radio Memory; Installing The Back-Up Battery; Installing The Solar Power System Kit Model Solekit - Nice Filo Instructions And Warnings For Installation

9.4 - DELETING THE MEMORY OF THE INDIVIDUAL TRANSMITTER FROM THE CONTROL UNIT'S MEMORY

the transmitter to be cancelled and simultaneously be able to access the control unit (before proceeding, open the gearmotor – Fig. 9).
• Procedure with transmitter memorised in Mode 1
01. On the control unit (Fig. 29) press and hold button P4 until the end of the procedure
02. When led L4 lights up, while keeping button P4 pressed , press and hold also any button of the transmitter to be cancelled, until led L4
then release both buttons .
Repeat the procedure for each transmitter to be cancelled.
• Procedure with transmitter memorised in Mode 2
01. On the control unit (Fig. 29) press and hold button P4 until the end of the procedure
02. When led L4 lights up, while keeping button P4 pressed , press and hold also the button of the transmitter to be cancelled, until led L4
then release both buttons
Repeat the procedure for each transmitter to be cancelled.

9.5 - COMPLETE DELETION OF THE RADIO MEMORY

the control unit (before proceeding, open the cover of the gearmotor – Fig. 9).
01. On the control unit (Fig. 29) press and hold button P4 .
02. Check that led L4 lights up for 4/5 seconds, that it switches o then ashes 3 times.
03. Precisely at the 3 rd ash release button P4 .
04. Check that led L4 emits very fast ashes.
05. Check that led L4 emits 5 slow ashes = deletion completed.
9.6 - INSTALLING THE BACK-UP BATTERY (model PR100)
installation and programming stages
To install the back-up battery and connect it to the control unit, see
When the automation is powered by the back-up battery, 60 seconds after a manoeuvre is completed the control unit
consumption (very important when the automation is powered by a battery )

9.7 - INSTALLING THE SOLAR POWER SYSTEM KIT model SOLEKIT

C
by the electricity grid at the same time
30
PR100
1
2
13 – English
Fig. 30 and consult the respective instruction manual.
.
.
.
must be made exclusively after completing all the
Fig. 31 and consult the relevant instruction manual.
31
SOLEKIT
1
2
29
Aerial
L4 L4 L3 L3
L4
P4
P4 P4 P3 P3
automatically switches o the
IT MUST NOT BE POWERED
1
ashes
ashes
Flas h Flash
Fuse 1.6A T F use 1. 6A T
OGI OGI
ECSbus E CS bus
Stop S top
S bS Sb S
L3 L L 3 3 L2 L2 L1 L 1
Sb S S bS
P3 P 3 P 3 3 P2 P 2 P 1 P1